INSTRUCTION MANUAL
DP-ST22
DP-ST21
DP-ST20
PLASMA MONITOR (DISPLAY)
STAND
S
T
A
N
D
Thank you for purchasing the Daewoo Electronic Plasma Monitor stand. This stand is
specifically designed only for the Daewoo Plasma Display. To ensure the safe operation of
the unit, please read these instructions before installing.
PLASMA DISPLAY STAND
2. IMPORTANT SAFETY INSTRUCTIONS
PLEASE FOLLOW THESE INSTRUCTIONS FOR YOUR SAFETY
PLEASE KEEP THESE INSTRUCTIONS FOR YOUR SAFETY AND TO PREVENT ANY DAMAGE TO THIS UNIT.
WARNING : Disregarding
When handling Display glass, be careful not
apply any pressure on it.
these instructions can result in
WARNING
serious injury.
CAUTION : Disregarding these
instructions will result in the
mistreatment of the unit and
can result in injury or damage
to the unit.
CAUTION
When assembling, be sure to use the enclosed
parts and make sure all parts are tightly
screwed.
When assembling, do not alter or modify any
parts
(If screws come loose, it can result in an
electric shock and unwanted accident)
(Doing so may cause the unit to fall and break)
When installing, be sure to have at least two
people handling the unit.
When attaching stand to plasma display, be
sure to cover the surface to protect from
accidental damage.
S
T
A
N
D
(If the unit is dropped, it may result in
damage to the unit and injury to your person)
(It may result in unwanted marks on the units,
if working without the protective covering)
2
3. ASSEMBLING INSTRUCTIONS
HOW TO DISPOSE OF THE PLASMA MONITOR WRAPPER
1
.
.
First dispose of the wrapping band and
raise the top box to open.
Afterwards, dispose of the Styrofoam
and remove the vinyl covering.
HOW TO DISPOSE OF THE PROTECTIVE CAP.
2
.
.
Place a protective covering over the
surface you will be working on and lay the
plasma display as shown below.
As shown below, unscrew the screws and
take out both of the protective caps.
3
PLASMA DISPLAY STAND
ASSEMBLING THE PLASMA DISPLAY STAND
3
.
.
Slide the stand under the plasma display
like the picture below.
Open and take out the stand from the
box and remove wrapper.
.
Use the enclosed 2 M5 screws to
secure the assembled stand.
M5 Screws
S
T
(Picture of a properly installed stand
and display)
A
N
D
4
4. DISASSEMBLING INSTRUCTIONS
DISASSEMBLING PLASMA DISPLAY STAND
.
.
Place a protective covering over the
surface you will be working on and lay the
plasma display as shown below.
Completely unscrew the secured 2
screws.
.
Pull the stand away from the plasma
display to disassemble.
5
|