Installation Instructions
Sheet 1 of 2
Large, OUTDOOR
YR (30 1/2")
(Yoke mount, Remote ballast)
Visor and Non-Visor
Warning: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician. Do not
mount fixtures vertically.
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
Exploded view and part call-out
Mounting yoke to outdoor surface
1
Outdoor J-box
(by others)
#6-32 x 1/2
Socket cap screw 1/2" Compression
(x2) fitting
Yoke end cap
Yoke
#6-32 x 1/4
screw(x2)
Yoke end cap
Yoke end cap
#10-32 x 5/8
End screw (x2)
1/4 Fasteners
(by others) (x4)
1. To secure yoke to outdoor surface, the fixture head must be
removed. First, remove both #10-32 x 5/8 end screws.
2. Remove one #6-32 x 1/4 screw to remove yoke end cap and
fixture head. Place both fixture head and yoke end cap in a
safe place.
3. With fixture head and yoke end cap safely stored, secure
yoke to outdoor surface using four(4) appropriate 1/4"
#10-32 x1
End screw
#6-32 x 1/4
#6-32 x 5/8
Socket cap screw
(x3)
Screw (x2)
1/4" Fasteners
(by others)
Fixture head
fasteners (by others).
2
3
Wiring and sealing outdoor fixture
Aiming the fixture
#6-32 x 1/2
Socket cap screw
(x2)
#10-32 x 5/8
end screws
1/2" Compression
fitting
Fixture head
indicator
#6-32 x 5/8
Socket cap screw
(x3)
40
Yoke arm indicator
1. To seal fixture head, after installing lamp, all screws and
latches must be secured on door face. Holes above latches
receive the #6-32 x 1/2 socket cap screws. The center hole(s)
receive the longer #6-32 x 5/8 socket cap screw.
2. Slide 1/2" compression fitting down fixture head wire and
splice wit power feed, ensuring all connections are properly
matched. Seal 1/2" compression fitting to outdoor surface and
ensure a watertight seal.
1. To aim fixture, loosen both #10-32 x.625 end screws. When
the PointGrabTM system indicators are lined up, the slope
of the lens face is 40-degrees. Each subsequent notch is
an additional 10-degrees.
2. When the fixture head is adjusted to the desired angle, re-
tighten end screws to secure the position.
ADY071449 Rev A (ECN070295)
|